Środki ostrożności Craftsman 358 350811

Subskrybuj nasze sieci społecznościowe, aby być na bieżąco z najnowszymi aktualizacjami!

Komentarz

More comprehensive information than other videos of the same machine. Well done!

Very good video and very helpful. I had trouble feeding the fuel lines in and brought a long needle nose player that helped grab the line in the tank and pull it through. Your video was very good quality and well done. Thank you

Great video. I really appreciate you taking the time to detail out the lines and explain. Helped me replace mine in no time. Thank you.

I can't believe I got it running again! Thanks for the video. My carburetor is a little different and has both fuel lines on the right side. The top was the fuel inlet (from the filter) for anyone who has the same one. I'll admit though getting those new fuel lines into the tank was a pain!

This was PERFECT to get mine fixed! My only three moments of "What the" Was with the carburetor being in so long the seal was sticking it. Just nudged it with a screwdriver and off it went. The second was trying to thread the hose through, That was tough, (good call with the 2 cycle oil) and then I had a pair of curved needle nose pliers. Lastly, the smaller hose had a small Inside Diameter making it hard to put on the fuel filer and back onto the carburetor, I just grabbed a lighter to warm the end of the hose up a bit and that did the trick. Excellent video!

Just found this same chainsaw in a shed behind my new house. Had the exact same problem. Thanks to you I got an almost-free chainsaw. Excellent video, took no time to do it.

Thanks for the video! I have the exact same chainsaw that needs a tune - up. Really helpful, liked and subscribed!

Great job on the video. Very clear, no wasted time, like the way you sped through certain parts.

excellent video great instruction clear picture no loud music to distract you. My fuel lines were already falling apart so the routing was difficult. really good job

Thanks for the video. I recently purchased this Chainsaw and discovered the fuel line was rotted. I followed your video step by step and got the job done. A few adjustments to the carb and it runs well. Thanks again!

Thanks, glad I saw this before tearing into it. My problem is that when it uses the gas the tank isn't venting and gets a vacuum going. You can hear it suck air in when you take out the cap. Was there anything in there that you saw that could be blocking the tank vent, or where is it? The saw is a couple of years old but has very little run time. Everything looks fine, the hoses appear to be in great shap, but I'm afraid some varnish has formed inside and blacked the vent. Thanks if you see this, muchly appreciated.

THANK YOU for this video. You saved me from having to buy another chain saw ($200.00-250). Followed your instructions and saw started right up and is running like new. THANKS AGAIN!!!!!!!! 5-23-2019

Thank you.Just what I needed.I got it done

Thanks a ton. Doing some after-storm cleanup and of course that's when my fuel line comes apart. This got me up and running again. Excellent, clear instructions and diagrams.

Very well done video! Outstanding job!

Thank you for this video sure did help me!! Just a question how was the idle when y'all put back together ? Thanks

Great job, mine was a slightly different model, but your video was a great help.

-Wonderfully done ... I have been going through vids on this project and they left me frustrated ... This vid made the job just that simple... as you presented it. - T/Y.

Thank you! The timing of your video

Thank you so much for the video!! You saved me a ton of work!!

.

Zostaw komentarz

#0